High Head Slurry Pumps are end-suction, split-type centrifugal slurry pumps that provide excellent wear life while maintaining efficiency over the wear cycle, providing optimum total operating costs.
High Head Slurry Pumps are widely used in ball mill discharge rod mill, nickel silicate pulp, coarse sand, coarse tailings, phosphate matrix, mineral concentrate, bottom ash / fly ash, lime powder, oil sands, ore, fine tailings And other industries. Phosphoric acid, coal, flotation, process chemistry, pulp and paper, FGD, wastewater
Impellers - Various metallurgical options - Pumping blades on the rear and front (on closed impellers) reduces recirculation in the high head slurry pump and helps prevent seal contamination - optional straight or semi-Francis blade castings (specific sizes 3 to 8 blades)) offers a wider range of hydraulic options in a single size
LINERS - Heavy Duty High Chromium Lining - Effective engineering connection mechanism with threaded bolts corresponding to unreliable glue
THROATBUSH - Adjustable through openings to solve long-term wear and increase efficiency
Chemical compatibility - Operating pH range 3 to 14 - especially corrosive chemicals treated with various elastomeric wetted parts
SEALS-Schurco offers a variety of sealing options to meet any process requirements
EXPELLER (Centrifugal Seal) - Provides low flow water flushing or zero flow (grease lubrication) options to provide an excellent seal that prevents or restricts the introduction of seal water
STUFFING BOX - Seal and seal seals
Bearing assembly - All bearings assemble the highest quality tapered roller bearings in a controlled environment to prevent contamination of the lubricant and casing - Extra large shaft diameter and reduced wet end overhang contribute to long life and reliability in the field
Enclosure - Separate design for easy access and maintenance of wet parts - Cast ductile iron with a large number of external ribs provides higher pressure rating and long-term reliable service - Easy to achieve casing pressure up to 750 psig
Base - One-piece base with integrated adjustment mechanism for impeller clearance in the pump-bearing assembly, locked to the base with four heavy-duty bolts - Three custom design mounting modes are available: overhead with integrated single-base system Side-by-side adjustable motor mounting and direct coupling to precise internal alignment (optional VFD package)
